American Car Craft Challenger 5.7 and SRT 8 Shifter Plate Brushed Auto 2008-2013 User Manual
Page 2
We can not be responsible for kits not sticking do to improper preparation!
PLEASE NOTE:
Installation errors are NOT manufacturing defects and parts can
NOT be RETURNED due to improper installation.
1. Once your areas have been prepared use the adhesive promoter tubes (provided)
to wipe the areas of your dash/door that will be covered with your new stainless
pieces. Allow a few seconds to dry. You have been provided with attachment
tape test strips. Use one of these to test the tack. If it seams to stick well then
you can proceed with your installation.
2. Your new part comes with two pieces, one base plate and a trim ring that’s goes
around the edge of the base plate. By centering the base plate around the holes
for P,R,N,D..The gap around the edge will not be the same all the way around
due to the flexibility in the plastic should that the shifter plate is centered
in..This is where the ring comes in hand and you use that to finish off the edges
of the part so that it looks finished..
3. IMPORTANT!! Before you remove the liner for permanent attachment place
each piece into position and check the fit and also get acquainted with just how
each part sets in place. It WILL be necessary to form a few of the parts by hand
to CONFORM to the shape of your center console to insure a nice perfect fit
without forcing the shape. Once you are satisfied with the shape and fit peel the
red release liner and firmly press each piece into position.
Note: EXTRA CARE must be taken when cleaning your dash kit. It is a good idea to lightly
dust your kit with a clean soft cloth first in order to prevent any particles from
scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free
glass cleaner.
If any questions occur during installation please contact American
Car Craft @ 727-861-1500
Thank you and enjoy your purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520