Attachment tape test strips – American Car Craft Challenger Door Badge Plate Brushed "SRT8 with Colored Carbon Fiber inlay 2008-2013" User Manual
Page 2
armor all or any such surface protector; installation will NOT work unless these
treatments have first been removed using special chemicals. PLEASE REFER
TO THE SPECIAL PREPARATION INSTRUCTION SHEET ENCLOSED.
We can not be responsible for kits not sticking do to improper
preparation!
PLEASE NOTE:
Installation errors are NOT
manufacturing defects and parts can NOT be
RETURNED due to improper installation.
1. Once your areas have been prepared use the adhesive promoter
packs/tubes (provided) to wipe the areas of your dash/door that will be
covered with your new stainless pieces. Allow a few seconds to dry. You
have been provided with
attachment tape test strips
. Use one of
these to test the tack. If it seams to stick well then you can proceed with your
installation. If you can not get the test tape to stick please refer back to the
special preparation instruction sheet and repeat those procedures.
2. IMPORTANT!! Before you remove the liner for permanent attachment
place each piece into position and check the fit and also get acquainted
with just how each part sets in place. It WILL be necessary to form a few
of the parts by hand to CONFORM to the shape of your dash to insure a
nice perfect fit without forcing the shape. Once you are satisfied with the
shape and fit peel the red release liner and firmly press each piece into
position.
If any questions occur during installation please contact American Car
Craft @ 727-861-1500
Thank you and enjoy your purchase!
Note: EXTRA CARE must be taken when cleaning your dash kit. It is a good
idea to lightly dust your kit with a clean soft cloth first in order to prevent
any particles from scratching it. Then wipe (using a new clean soft cloth)
with a good quality streak free glass cleaner.
American Car Craft
18924 Sakera Rd.
Hudson, FL. 34667
727.861.1500