Hyundai H-DVD5063 - Manual (Page 16)

H-DVD5063 ( www.hyundai-electronics.ru ) 16
DIGITAL OUTPUT
SPDIF off: no digital signal out (coaxial output off), only analog audio output.
All: digital signal output in the original format recorded in the disc.
PCM only: digital signal output in the decoded PCM form.
LPCM OUTPUT
Select PCM frequency at 48 kHz or 96 kHz
Note: some amplifier don't support 96 kHz sampling and cause coaxial output abnormal.
The initial factory setup is 48 kHz.
Dolby digital setup
DUAL MONO
Stereo: stereo output signal,
L-Mono: left output signal,
R-Mono: right output signal,
Mix-Mono: left and right output average signal.
DYNAMIC
If watching large dynamic scope movie program at night, to select this mode you can reduce the
volume to a very low level, at the same time, to keep the fine details sounds. In this case, this doesn't
disturb the family and keep the quality sounds.
Channel delay
You can set the speaker distances in the real conditions. Press the UP/DOWN cursor buttons to select
the speaker, Press the LEFT/RIGHT cursor buttons to adjust the distance.
Equalizer setup
SOUND MODE (No this setup in 2CH DVD)
Several EQ modes are available. You can select one according to your preference and the disc
content.
SELECT BASS BOOST, SUPER BASS OR TREBLE BOOST
On means strengthen the corresponding audio frequency range.