American Car Craft Corvette Vent Spears only 6Pc Polished 2005-2012 C6 only User Manual
Page 2
3. You have been provided with a paper template for the suggested position of each
spear. Cut the template along the lines indicated. Place the template along the
fenders edge so that it lines up with the very bottom of the vent hole. You will see
that the three cutouts created will evenly and correctly position each of the spears.
The spears are marked starting from top to bottom 1P, 2P and 3P for passenger
side and 1D, 2D and 3D for the driver’s side. Before you begin permanent
installation set each spear into place to get acquainted with its position. Each
spear tip is designed to fit into the vent hole and to just touch the vent grille.
NOTE: THEY ARE NOT DESIGNED TO HAVE FULL CONTACT WITH
THE SIDE VENTS as this will create an unsightly gap between the fender and the
spear.
4. Once you have a good idea of the spears position simply peel and stick all three
spears into place. Press firmly to set a nice bond. Do not get wet for 24 hours.
5. Remove the template and repeat steps 1-3 for the opposite side.
6. You have been supplied with two lengths of chrome trim (Optional) This trim has
been supplied to be placed at the outer edge of the vent opening to add a nice
finished appearance. Simply clean the vent ridge with household rubbing alcohol
then swipe with the adhesive promoter provided. Once preparation is complete
simply peel the red release liner from the precut trim and set in place. Pressing
firmly to set.
If any questions occur during installation please call
American Car Craft at 727-861-1500.
Thank you and enjoy your purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com