American Car Craft Mustang Fuel Rail Covers 5.0 GT 2Pc Perforated w_Cap 2011-2012 User Manual
Page 2
1. Thoroughly scrub clean the entire surface of the factory fuel rail/coil pack covers to remove any
and all road grime and dirt. Then swipe the areas with the adhesive promoter provided. This
chemical not a cleaner but an adhesive accelerator and must be used as such in order to expect
a good long lasting bond.
2. Before you permanently attach the new stainless covers take a moment to set each cover in
place to get acquainted with their intended position as well as the overall fitment and contour.
Although the new covers come to you preformed it may be necessary to further tweak their
shape by hand in order to achieve the most contact for a good bond. Once you have everything
ready simply peel the red release liner from the back of each cover and then firmly press them
to the stock cover making sure that the attachment tape has made a good and complete
contact. Remove the protective liners.
3. You kit has come to you containing 8 chrome decorative half shell top hat covers and 4 tall top
hat covers, each containing butyl putty for mounting. You have also received 4 small zip ties.
Once you have finished installing the stainless covers and then installed the covers onto your
engine simply press the 8 half shell covers over each of the 8 coil pack connectors. This will give
these connectors a nice finished look.
4. The 4 remaining covers are to be applied to the 4 electrical sensors just in front of each fuel rail
cover. Since the wires for these sensors are sort of randomly leading up to the censors. Use the
small zip ties to strap the wires at the sensors base around to the back of the sensor and then
trim the zip tie. This will create a nice neat arrangement for the new chrome caps to set atop the
sensors giving a nice custom and complete appearance. Simply press them onto each censor
with the notch in the covers over the wires you just strapped to the censor.
If you have any questions during installation please call American Car Craft at 727-861-1500.
Thank you and enjoy your new purchase.
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520