American Car Craft Challenger Firewall Brushed 2008-2012 5.7L only - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
CHALLENGER STAINLESS FALSE FIREWALL 5.7
PART#153006
patent pending
PARTS INCLUDED:
___ 1-Slightly Angled Extension Bracket
___ 1-¼-20 nut and
¾” Bolt
___ 2-Chrome ¾” Oval Head Screws
___ 1-Decorative Chrome Cap Cover w/Velcro Cookie for SRT 8 Models Only
___1-Adhesive Promoter Pack for SRT 8 Models Only
PLEASE READ ENTIRE INSTRUCTIONS BEFORE
BEGINNING INSTALLATION!
Your new firewall comes to you with a protective liner. Do not remove liner until
step 4.
1. Remove engine cover.
2. You will notice a large vacuum valve bolted to the shock tower just to the
left side of your engine bay. (Passenger side) Unbolt this valve and use
the same bolt to attach the extension bracket (provided). Then attach the
valve to the bracket using the ¼-20 nut and bolt (provided). This
procedure will force the vacuum valve to sit in a further back position in
order to allow the false firewall placement. You will also need to reroute
the water tank fill line. This line has been routed by the factory across the
engine bay to the tank and is not very nice looking and can be pinched by
the firewall if left in position. To fix this simply remove the line from the
tank, reroute the line behind the aluminum block bracket that is mounted
to the shock tower pull it back up to the tank and reinstall. This will nicely
tuck the fill line out of the way and out of view.
3. Your new firewall panel comes to you flat. In order to achieve a nice
conforming fit along the wiper cowl gasket ridge it will be necessary to
slightly form the panel by hand. To do this you will need to remove it
shape it some and place it back into position several times until the panel