American Car Craft Corvette Z06 505HP Badges 4Pc Polished 2005-2013 C6 all User Manual
Page 2
bondable surface.
2. Now that all preparations have been made the next step will be to apply the accessory. In almost all cases it
will be very necessary to pre-shape the stainless part so that it conforms to the surface you are mounting it to, perfectly.
This is done by gently shaping the part by hand a little at a time so that when the part is placed in position it matches the
surface without having to apply pressure anywhere on the part to make it fit the shape of the surface. In other words it
will look like it has been installed perfectly, before you actually peel and stick it. If you take your time when forming the
part you will never have any problems with the part popping off in the future.
3. Now that you have a good surface prep and your part or parts have been hand shaped to match the surface
you can peel the red release liner from the back of the part. Keep in mind that the adhesive is very aggressive and it will
not allow you to reposition it once it has made contact with the surface. So go slow and sure. Once all hole and the
perimeters are lined up, set the part in place pressing firmly along the entire surface to bond the part and then remove
the protective liner. The bond will become permanent after twenty-four hours.
If any questions or problems occur during installation, please contact American Car Craft at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520