American Car Craft Corvette Battery Cover Perforated 2005-2007 C6 only User Manual
Page 2
2. You have been provided with a small stainless square. You will notice that this
square has a strip of attachment tape mounted to it. Peel the red release liner from
the tape and attach it directly to the under side of the hook you just treated. Place
the square in such a way that there will be about two of the three inches exposed
to the RIGHT SIDE of the black hook.
3. You have been provided with a countersink type drill bit. Drill a small counter
sunk hole directly into the black hook so that it will pierce the stainless square
attached underneath. Once this is completed you can permanently secure the
square by installing the black flathead screw provided. You have been supplied
with a flat black screw cap to seal the screw head.
4. With the bracket firmly in place partially remove the hood gasket from over the
battery area. Installing the new battery cover is simply a matter of tucking the side
of the unit under the gasket ridge and allowing the top of the cover to lay flat over
the square tab you just installed. You will notice that the upper part of the cover
will line up with the gasket ridge. Simply replace the gasket over both the ridge
and cover to complete the installation.
5. Remove protective liner.
Note: Care must be taken when cleaning your cover. It is a good idea to lightly
dust your cover with a clean soft cloth first in order to prevent any particles from
scratching it. Then wipe (using a new clean soft cloth) with a good quality streak
free glass cleaner. SEE ENCLOSED CARE SHEET!
If any questions occur during installation, please contact American Car Craft
at 727 861-1500.
Thank you and enjoy your new cover.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com