Cannot be returned due to improper installation – American Car Craft Camaro Door Panel Kick Plates Brushed w_Carbon Fiber "SS 2Pc 2010-2013" User Manual
Page 3
Installation errors are NOT manufacturing
defects and parts
CANNOT be returned
due to improper installation.
Before you remove the red liner for permanent attachment place the door
guard into position and check the fit. Your panel comes to you preformed
however it will be necessary to form by hand to insure a nice perfectly
contoured fit. When you are holding the panel up to the door it
should lay flat and conform to the shape of the door without forcing
it. (In other words it should look like it is installed and not be protruding
from the door panel in any way). Please refer to the picture at the end of
these instructions. Make note of its position. PLEASE NOTE: Metal will not
bend out of place itself so if it is properly formed and installed the panels will
remain in place.
5. Remove the red liner (be sure not to touch the adhesive) and carefully
reposition the door guard, press firmly on the panel to set.
6. Remove protective liner. Then repeat steps 1-7 for the other door.
If any questions occur during installation please contact American Car
Craft @ 727 861-1500.
Thank you and enjoy your purchase!
Note: Care must be taken when cleaning your door guards. It is a good
idea to lightly dust your door guards with a clean soft cloth first in order to
prevent any particles from scratching them. Then wipe (using a new clean
soft cloth) with a good quality streak free glass cleaner.
This is how your installed panels are designed to fit on your door panel.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com