Duro-Last T-Edge Plus - Manual

DATA SHEET
T-Edge Plus
“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012
Description:
The T-Edge Plus is designed with a double-folded drip
edge neatly concealing the vinyl-coated hook strip so it
is not visible from ground level. The system consists of
three separate components: a drip edge base, hook
strip, and splice plate that are hooked together to form
an aesthetically-pleasing edge.
Fabricated in 10’ lengths; 2” – 8” widths.
Top piece consists of a vinyl-coated hook strip
with a 6” attached membrane skirt. Bottom drip
edge piece available in any metal finish.
Does not require an overlapping allowance.
Ready to assemble inside and outside corners
are available.
Contact Duro-Last ® or EXCEPTIONAL ® Metals to
request a color chart, samples and information
regarding custom metals and finishes.
Energy Efficiency:
LEED ® and ENERGY STAR ® compliant; Recyclable.
Installation:
1. Attach to a wood nailer.
2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.
3. Install in accordance with Duro-Last detail
drawing #3555.
4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.
Codes and Standards:
ANSI/SPRI ES-1 Compliant for 3” – 8” in 24-
gauge galvanized and .040 aluminum.
Warranty:
Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.
Technical Services:
Product samples, detail sheets, color chips, and color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.
Material Gauge Finish
Aluminum .040 Mill or Kynar
®
Stainless Steel 24-gauge N/A
Bonderized Steel 24-gauge N/A
Galvalume 24-gauge Mill or Kynar ®