Duro-Last Fascia Base - Manual

DATA SHEET
Fascia Base
“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012
Description:
The Fascia Base functions as a fascia bar and cove
system, used with the 2-Piece Snap-On Cover. Can be
used on eaves, allowing water to flow over the roof
edge termination.
Fabricated in 10’ lengths and 3” – 8” widths.
Manufactured from 24-gauge Galvalume, 24-
gauge stainless steel, and .050 aluminum.
Contact Duro-Last
®
or EXCEPTIONAL
®
Metals to
request a color chart, samples and information
regarding custom metals and finishes.
Energy Efficiency:
LEED ® and ENERGY STAR ® compliant; Recyclable.
Installation:
1. A wood nailer is required if 1” or greater of
insulation is used.
2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.
3. Install in accordance with Duro-Last detail
drawing #3560.
4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.
Codes and Standards:
ANSI/SPRI ES-1 Compliant for 4” and 6”
base.
Warranty:
Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.
Technical Services:
Product samples, detail sheets, color chips, and color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.
Fascia Base shown with 2-Piece Snap-On Compression Cover.