PowerWalker VI 400 SE - Manual (Page 8)

VI: Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again the power switch.
6. Functions & Operation
I: DC Start Function
DC Start Function enables UPS to be started up when AC utility power is not available and battery is fully
charged. Just simply press the power switch to turn on the UPS.
II: Green Power Function
These Series are equipped with Green Power Function. If no load connects to the UPS, it will automatically
shut down in 5 minutes for energy saving while power failure. The UPS will restart while AC recovery.
III: AVR (Automatic Voltage Regulation)
If the quality of the incoming mains is poor, the AVR boosts a low incoming voltage or reduces a high one. The
load receives a voltage within the normal range.
IV: LED Indicator
VI 400SE/600SE/800SE VI 1000SE/1400SE/2000SE
Green ON - AC Mode 1
st
Green ON - AC Mode
Green Flashing - Backup Mode 1 St Green Flashing - Backup Mode
RED LED ON - Faulty
3
rd
to 5
th
green ON
- Load Level
- Battery Capacity (in
Backup Mode)
NEVER connect a laser printer or scanner to the
UPS unit, because in-rush current generated by
motor’s devices may cause the damage of the unit.
EN