PowerWalker VI 650 IEC - Manual (Page 6)

5. Installation and Initial Startup
Before installation, please inspect the unit. Be sure that nothing is damaged .
I: Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has adequate air flow around the unit,
and is free from excessive dust, corrosive fumes and conductive contaminants. Please place the UPS away
from other units at least 20 cm to avoid interference. Do NOT operate the UPS where the temperature
exceeds 0-40° C and the humidity is over 0-90 % RH.
II: Connect to Utility and Charge
Plug in the AC input cord to the 2-pole, 3-wire grounded wall outlet. For the best results, we suggest charging
the battery at least 6 hours with no load (no electrical devices such as computers, monitors, rtc.) connected
before initial use. The unit charges its battery while connecting to the utility.
EN