PowerWalker VI 650 LCD_UK - Manual (Page 6)

EN
4. Installation and Initial Startup
Before installation, please inspect the unit. Be sure that nothing is damaged.
I: Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has adequate air flow. Please
place the UPS away from other units at least 20 cm to avoid interference. Do NOT operate the
UPS where the temperature exceeds 0-40° C and the humidity is over 0-90 % RH.
II: Connect to Utility and Charge
Plug in the AC input cord to the wall outlet. For the best results, we suggest charging the battery
at least 4 hours before initial use. The unit charges its battery while connecting to the utility.
III: Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the power
switch of UPS unit, and devices connected to the UPS will be protected by UPS unit.
IV: Connect Modem or Phone for Surge Protection
Connect a single modem or phone line into surge-protected “IN” outlet on the back panel of the
UPS unit. Connect from “OUT” outlet to the computer with another phone line cable.
V: Connect USB Cable
To monitor the UPS status, such as unattended UPS shutdown and start-up, by using bundled
software, please connect the UPS and PC with USB cable included.
Do not attach a power strip or surge suppressor to the UPS.