Peerless-AV ACC615 - Installation - Manual (Page 2)

ISSUED: 05-23-02 SHEET #: 120-9012-4 10-29-07
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
2 of 2
Rotate toggler (A)
clockwise to wedge it
against inside walls
of metal stud.
Push into hole.
Pivot end of toggler (A).
Slide plastic cap
forward while pulling
back firmly on ring.
Break off excess.
FOR METAL STUD WALLS ONLY: Drill four 1/2"
(13mm) dia. holes through drywall and studs at
locations corresponding to wall plate. Insert togglers
(A) as shown below...
A
Align wall plate with
hole in wall and
fasten using
1/4-20 x 2.5" screw
(B) and 1/4"
washer (C).
wall plate
B
© 2004 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
A
∅ 1/2"
(13 mm)
• Product must be mounted through drywall that has a
minimum thickness of 1/2" and into metal studs, 26
gauge or heavier.
• Make sure that togglers are anchored into the center
of the studs as shown in figure 1. The use of an "edge
to edge" stud finder is highly recommended.
fig. 1
WARNING
C