Peerless-AV VPM25-J - Installation - Manual (Page 5)

ISSUED: 05-19-04 SHEET #: 081-9032-3 02-14-06
For customer service call 1-800-729-0307 or 708-865-8870. Visit the Peerless Web Site at www.peerlessindustries.com
5 of 5
If adhesive foam (H) is covering slots, trim foam (H) to expose slots. Insert four carriage bolts (D) into
slots of upper DVD mount (A). Loosely attach lower DVD mount (A) using four #10 SAE washers (F)
and #10-24 nylock nuts (E). This will allow access to the vertical adjustment screws of the upper mount
by being able to easily move the lower mount. Note: TV and TV mount not shown in illustrations.
Installing Multiple DVD/DVR/VCR Mounts
Adjust size of the upper DVD mount (A) to fit media player by loosening screws on both sides. Insert
media player and align front of player with front of TV on TV mount. Tighten vertical and horizontal
adjustment screws where shown on both sides until player securely fits in mount.
Note: To access the vertical adjustment screws of the upper mount, slide the lower mount to the side.
Repeat for the opposite side.
Center lower DVD mount (A) and securely tighten four nuts (E). Repeat beginning of this step to install
the media player into the lower DVD mount.
© 2004 Peerless Industries, Inc. All rights reserved.
Peerless and Jumbo are registered trademarks and Penta-Pin is a trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
• Do not stack more than three DVD/DVR/VCR Mounts
from a TV mount.
WARNING
• Stacked load cannot exceed 50 lb.
WARNING
UPPER MOUNT (A)
LOWER MOUNT (A)
H
VERTICAL
ADJUSTMENT
SCREW
DETAIL 1
E
D
F
UPPER MOUNT
LOWER MOUNT
MEDIA PLAYER
HORIZONTAL ADJUSTMENT
VERTICAL ADJUSTMENT