Peerless-AV PM610G - Installation - Manual (Page 3)

ISSUED: 07-16-01 SHEET #: 021-9007-4 09-10-07 3 of 5
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
NOTE: Fastners for concrete not included, order
two accessory kits #ACC205. For Concrete Walls
drill five 5/16" (8 mm) dia. holes to a minimum depth
of 1 3/4" (45 mm). Attach wall bracket (A) using
concrete expansion anchors as shown.
2
WARNING
• When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete
surface in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid
part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifica-
tions. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill
to avoid breaking out the back of the hole when entering a void or cavity.
• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
• Make sure that the wall will safely support four times the combined load of the equipment and all attached hard-
ware and components.
• Always attach concrete expansion anchors directly to
load-bearing concrete.
• Never attach concrete expansion anchors to concrete
covered with plaster, drywall or other finishing material.
WARNING
FOR PRODUCT SAFETY, USE ONLY... RAWL TM #5005
OR HILTI TM HL814 CONCRETE ANCHORS.
Order TWO #ACC205 accessory kits. Each contains three
.312 x 1.625 (8 mm x 41 mm) concrete expansion anchors.
concrete
anchor
A
Insert and hammer in anchor.
Tighten to 80 in • lb (9 N.M.) maximum torque. The
anchor will expand and grip inside the hole.
A • Tighten concrete anchor bolts firmly, but do not
overtighten. Overtightening can damage the bolts,
greatly reducing their holding power.
• Never tighten in excess of 80 in • lb (9 N.M.).
WARNING