Peerless-AV WSP470 - Installation - Manual (Page 3)

ISSUED: 02-10-00 SHEET #: 024-9003-5 08-04-05
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
3 of 3
E
Fasten all twelve screws (C) tight,
untill wall plate (A) is flush with wall.
Push toggler (D) through hole. Pull screw (C)
back untill toggler (D) hits the inside of the
metal stud.
Place screw (C) through
wall plate (A). Partially
fasten the toggler (D) to
the back of the screw.
Pivot ends of toggler (D)
90°.
∅
3/4"
(19 mm)
Drill 3/4" (19 mm) dia. holes
through drywall and studs.
Insert togglers (D) as shown
below...
Eight 1/4-20 x 1/2" phillips
screws (B) and eight washers
(E) are provided to attach
mount (sold separately) to
wall plate.
A
D
C
A
A
C
D
A
C
D
© 2005 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
• Make sure that mounting screws are anchored into the
center of the studs. The use of an "edge to edge" stud
finder is highly recommended.
WARNING
ALL OTHER MOUNTS
PLA-1
PLA-2
Note: See below for quantity of fasteners and proper holes to attach wall plate to wall.