Peerless-AV SPK811W - Installation - Manual (Page 3)

ISSUED:03-26-03 SHEET #: 087-9012-4 06-14-07
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
3 of 4
Attachment of Ball and Cap to Speaker
For Attachment to Speakers with a Keyhole on Back: Thread
keyhole adapter (M) into coupling (P) a few turns. Insert assembly into
keyhole on back of speaker as shown in DETAIL TWO. Hand tighten
coupling (P) until it fits tightly against back of speaker. Use 7/16” open
end wrench to tighten coupling (P) until it is secured to speaker. Insert
ball (D) through cap (C) and thread into coupling (P). Hand tighten ball (D)
until it is secured to coupling (P). For Attachment to Speakers with a Single Threaded
Insert: For 1/4-20 size threaded inserts, thread one locknut
(K) halfway onto ball (D). Insert ball (D) through cap (C) and
thread directly into threaded insert on back of speaker.
Tighten locknut (K) until it is securely against back of
speaker. For M5 and M4 size threaded inserts, use reducer
(N) or (O) to thread ball (D) into threaded insert. Note:
Locknut (K) is not used with reducer (N) or (O).
For Attachment to Speakers with More Than One Threaded Insert: Insert ball (D) through cap (C) and attach mounting plate (Q) using two
serrated locknuts (K) as shown in DETAIL THREE. Attach mounting plate (Q) to speaker using two or four screws (E),(F),(G),(H) or (I) as needed
for speaker threaded insert pattern.
D
C
Q
K
K
DETAIL THREE
Q Q
M4 screws (E) and 10-32
screws (I) will require
washers (L) when used in
two threaded insert
applications.
E, F, G or H
E, F, G, H or I
For Speakers with Four Threaded Inserts For Speakers with Two Threaded Inserts
Use two 7/16” open end wrenches to
tighten locknuts (K).
Note: If you are unable to attach your speaker to the Universal Speaker Mount please contact our customer service department for assistance prior
to returning this product to the store from which it was purchased.
DETAIL TWO
P
M
Speaker
C
D
P
Use reducer
(N) for M5
inserts Use reducer
(O) for M4
inserts
D
C
K
2
Y X
W
For Speakers with Two Keyholes
Q
L
W
L
X
Y
Q
DETAIL FOUR
SPEAKER
For Attachment to Speakers with Two Keyholes: Insert ball (D) through cap (C) and attach mounting plate (Q)
using two serrated locknuts (K) as shown in DETAIL THREE. For each keyhole, slide a M4 serrated washer (X) onto
a M4 x 16 mm socket pin screw (Y). Tilt and drop both M4 serrated washer (X) and M4 x 16 mm socket pin screw (Y)
into slot on speaker back and slide into locking position. Place bracket mounting plate (Q) onto M4 x 16 mm socket pin
screws (Y). Fasten #10 flat washer (L) then M4 KEPS hex nut (W) onto each M4 x 16 mm socket pin screws (Y) as
shown in DETAIL FOUR.