Peerless-AV WSP816 - Installation - Manual

ISSUED: 03-24-09 SHEET #: 125-9056-1
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
1 of 2
Models: WSP816,
WSP816-W
Use a stud finder to locate stud centers. Use wall
plate (A) as a template to mark stud centers
through slots. Drill 3/4" (19 mm) dia. holes through
drywall and studs. Insert togglers (E) as shown
below. Six 1/4-20 x 2.5" phillips screws (D) and six
washers (C) are provided. Place screws (D) through
wall plate (A). Partially fasten the toggler (E) to the
back of the screw. Pivot ends of toggler (E) 90°.
• Make sure that mounting screws are anchored into
the center of the studs. The use of an "edge to edge"
stud finder is highly recommended.
WARNING
A
B C
D
E
A
E D
E
D
A
A
D
C
E
Installation and Assembly:
Metal Stud Wall Plate for FPS-1000 or SP850
IMPORTANT! Read entire instruction sheet before you start installation and assembly.
Maximum Load Capacity: 150 lb (68 kg)
D
E
A
C
Push toggler (E) through hole.
Pull screw (D) back until toggler (E) hits the inside of
the metal stud. Fasten all six screws (D) tight, until
wall plate (A) is flush with wall.
WSP816 WSP816-W
Description Qty. Part # Part #
A 16" wall plate 1 024-1047 024-2047
B 1/4-20 x 1/2 phillips head screw 4 510-9108 510-9108
C 1/4" flat washer 10 540-9440 540-9440
D 1/4-20 x 2.5 phillips head screw 6 520-9522 520-9522
E toggler 6 590-1093 590-1093
Parts List