Or h g, Ac f c – Peerless-AV ACC840 - Installation User Manual
Page 4
ISSUED:12-14-01 SHEET#: 055-9068-3 11-10-04
Visit the Peerless Web Site at www.peerlessindustries.com
For customer service call 1-800-729-0307 or 708-865-8870.
4 of 4
Place one finishing cap (C) on each end of
anti-vibration mount (A).
When attaching anti-vibration mount (A) to flush mount tube or extension
column (both tube and column are sold separately ), tighten at least four
complete turns ending with one of the small threaded holes aligned with slot
in the end of flush mount tube or extension column. Insert and tighten one
M5 screw (H) to lock tube position (shown below on right side). Note: For
security the M5 philips screw (H) can be replaced with M5 socket-pin
screws (G).
OPTIONAL:
Place grommet (F) on anti-
vibration mount (A) and place one finishing cap
(C) on other end of anti-vibration mount (A).
Route cords through extension column and out
cord management holes in anti-vibration mount
(A). Note: If using Vector Pro projector
mounts, you will need accessory ACC 800
to route cords through column.
or
H
G
flush mount tube or
extension column
(sold sparately)
A
C
F
C
© 2004 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
Unistrut
®
is a registered trademark of Peerless Industries, Inc.