Peerless-AV DS25_SV_S_S-SV_SW_W - Installation - Manual (Page 5)

ISSUED: 04-26-04 SHEET #: 081-9028-3 02-14-06
For customer service call 1-800-729-0307 or 708-865-8870. Visit the Peerless Web Site at www.peerlessindustries.com
5 of 5
If adhesive foam (I) is covering slots, trim foam (I) to expose slots. Insert four carriage bolts (C) into slots of upper
DVD mount. Loosely attach lower DVD mount using four #10 SAE washers (F) and #10-24 nylock nuts (E). This will
allow access to the vertical adjustment screws of the upper mount by being able to easily move the lower mount.
Installing Multiple DVD/DVR/VCR Mounts
DETAIL 1
E
C
F
UPPER MOUNT
LOWER MOUNT
Adjust size of the upper DVD mount to fit media player by loosening screws on both sides. Insert
media player and align front of player with front of TV on TV mount. Tighten vertical adjustment screws
and horizontal adjustment screws where shown on both sides until player securely fits in mount.
Note: To access the vertical adjustment screws of the upper mount, slide the lower mount to the side.
Repeat for the opposite side.
Center lower DVD mount and securely tighten four nuts (E). Repeat beginning of this step to install the
media player into the lower DVD mount.
Note: TV and TV mount not shown in illustrations.
UPPER MOUNT
LOWER MOUNT
MEDIA PLAYER
I
© 2004 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
VERTICAL
ADJUSTMENT
SCREW
VERTICAL ADJUSTMENT SCREW
HORIZONTAL ADJUSTMENT SCREW
• Do not stack more than three DVD/DVR/VCR Mounts
from a TV mount.
• Stacked load cannot exceed 50 lb (23 kg).
WARNING