Peerless-AV ACC600 - Installation - Manual

ISSUED: 08-22-00 SHEET #: 128-9112revB 08-07-01
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
1 of 1
Muti-Display Interface Bracket
PATENT PENDING
ASSEMBLY INSTRUCTIONS
Before beginning assembly...
Please read entire instruction sheet and check the parts list to ensure that
all components have been included.
Recommended tools: Adjustable wrench, Phillips screwdriver
Notch
Washer
Lock Washer
Hex Nut
"U" Bolt
Model:
ACC 600
IMPORTANT: Insert the
M5 x 10mm screw in the
threaded pipe fitting as
directed in the
extension column
instructions. If you are
using an extension pipe
without a notch, drill a
11/64
(0.172") dia. hole
through the pipe and
insert the screw through
the pipe. Failure to do so could cause the
assembly to fail.
3.
Now tighten Hex Nuts to a maximum of 25 FP
(34NM) so that the lock washer becomes flat.
Mount your bracket according to the instruc-
tions provided with it.
Parts List
Description Qty Part #
Muti-display interface brkt 1 128-1141
Support Pipe 4" 1 139-1083
"U" Bolt 2 520-1088
Flat Washer 4 540-9407
Lock Washer 4 540-9424
Hex Nut 4 530-9308
M5 x 10 mm phil. screw 1 520-9250
Bracket 2.
Fasten Support pipe into bracket until pipe is
tight and align notch with hole on bracket or
attach the extension column according to the
instructions provided with it. Use a level to
make sure the column is plumb and make
adjustments as necessary.
1.
Select the location on the pipe for posi-
tioning bracket and position the "U" Bolts
over the top as shown. Then attach the
bracket underneath with the Hex Nut, lock
washers and washers. Note: the direction
of the bracket will be UP for mounting to
extension columns and DOWN for pipes
(as shown). Tighten nuts snugly.
IMPORTANT: It is the responsibility of the
installer to verify that the pipe will safely
support the combined load of four times all
attached hardware and componentry.
This Peerless product is intended for use with UL approved monitors and TV's only and must
be installed by a qualified professional installer.
* Combined
Load
Capacity:
1200 lbs.
*Total weight of components
and hardware
2" dia.
max.
This bracket will only be used
on round 2" (max.) pipes to
mount a TV bracket.
Pipe not
included
2" dia.
max.
This bracket will only be used
on round 2" (max.) pipes to
mount extension columns.
© 2001 Peerless Industries, Inc. All rights reserved.
Peerless is a trademark of Peerless Industries, Inc.
Support Pipe