Peerless-AV HLG440-PH-Q10 - Installation - Manual (Page 3)

3 of 4 ISSUED: 10-30-10 SHEET #:125-9164-2 09-14-11
3 B
Secure swivel plate assembly ( A)
to bottom of display base using
three 10-32 x 3/8" flat head self
drilling screws ( B) in 32" or 42"
orientation.
NOTE: Make sure that screws in
display base align with slots and
holes in swivel plate assembly ( A)
as shown below.
FRONT
42" Display Base Attachment Location 32" Display Base Attachment Location
A
ARROW INDICATES
FRONT OF SWIVEL
PLATE ASSEMBLY
.88"
FRONT
DISPLAY BASE
SCREWS
DISPLAY
BASE
SCREWS
Mounting using Security Slope Nuts (Optional)
For added security replace two
of the washers and locknuts with
slope nuts.
Hand tighten slope nuts ( D) onto
two of the carriage bolts ( C) until
snug against bottom of table as
shown in Detail 2.
Thread another slope nut ( D)
upside-down, about two turns
from first slope nut ( D) as shown
in Detail 3.
Insert a 5/8
" open box wrench
between both slope nuts ( D) and
tighten
as shown in detail 4.
7
(note orientation of plate to base) (note orientation of plate to base)
Detail 4
TIGHTENING
SLOPE NUT (G)
D
5/8" OPEN BOX WRENCH
TIGHTENING
SLOPE NUT (D)
C
M
D
Detail 2
Detail 3
D
BOTTOM OF DESK
BOTTOM OF DESK
NOTE: Avoid jamming both slope nuts (D)
together, doing so may make it difficult to remove
slope nut used for tightening. After slope nut is
secure remove bottom slope nut.
LEAVE SPACE
IN BETWEEN
SLOPE NUTS