Peerless-AV DCT900 - Installation User Manual
Warning, Parts list
A
B
C
D
E
F
3" (76 mm)
adjustment range
B
PART #
QTY.
DESCRIPTION
A 128-0424
1
tray
B 128-1273
2
clamps for i-beam
C 520-1018
4
1/2-13 X 2" square head bolt
D 520-1019
4
1/2-13 X 1" carriage bolt
E 530-1008
4
lock nut 1/2-13
F
540-2005
4
flat washer 1/2-13
IMPORTANT! Read entire
instruction sheet before you
start installation and assembly.
Before you start make sure
all parts shown below are
included with your product.
Installation and Assembly - Multi-Display I-Beam Clamp for 4"-7" Beams
Model:
DCT 900
Note: Some parts may appear slightly different than illustrated.
Note: For each step see corresponding illustration.
Attach brackets (B) to tray (A) using four 1/2-13 X
2" square head bolts (C), washers (F), and lock
nuts (E). Do not fully tighten. Start four 1/2-13 X 1"
carriage bolts (D) into clamps (B).
Adjust clamps (B) securely around I-Beam. Tighten
(C,F,E) securely. Tighten four bolts (D) securely.
Attach the extension column according to the
instructions provided with it. Use a level to make
sure the column is plumb and make adjustments as
necessary.
B
D
I-Beam
Maximum load rating 600 lb (272.2 kg) Combined weight
to all attached hardware and components is not to exceed
600 lb (272.2 kg)
ISSUED: 06-11-02 SHEET #: 128-9136-3 04-21-05
Visit the Peerless Web Site at www.peerlessindustries.com
For customer service call 1-800-729-0307 or 708-865-8870.
1 of 1
© 2004 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
• If multi-display system, in combination with compo-
nents exceeds 600 lb (272.2 kg) it therefore exceeds
the maximum load. Heavy Duty I-Beam Clamp with
Decoupler will not safely support a combined load
which exceeds 600 lb (272.2 kg)!
WARNING
Parts List