Peerless-AV PLAV70-UNLP-GB - Installation - Manual (Page 9)

9 of 14 ISSUED: 11-21-06 SHEET #: 202-9180-7 06-14-12
Insert two M10 screws (F) into swivel box on arm assembly (C) as shown. Leave approx. 1/4" of exposed thread.
C
.25" F
• After tilt is adjusted, all fasteners must be tightened.
Failure to do so will result in damage to the mount.
CAUTION
SWIVEL BOX
6
Hook tilt-roll assembly (B) onto M10 screws (F).
Insert carriage bolt (I) into slot of swivel box as
shown in fi gure 6.1. Install nylon washer (G) and tilt
adjustment knob (H).
Install remaining two M10 screws (F) as shown in
fi gure 6.2. HAND TIGHTEN all four M10 screws to
allow for tilt adjustment. Remove tape from carriage
bolt (I). For tilt adjustment, gently push back on the
top of plasma to relieve pressure on knob. Adjust tilt
to desired position and tighten tilt adjustment knob
(H), then securely tighten all four M10 screws (F)
using 6 mm allen wrench (U).
6-1
6-2
Adapter bracket not shown for clarity. Adapter bracket not shown for clarity.
I
B
F
I
B
F
H
SWIVEL BOX
fi g 6.1
fi g 6.2
G
• Use an assistant or mechanical lifting equipment to safely lift and position the plasma TV.
WARNING