Peerless-AV WL-ST660-200 - Installation - Manual (Page 7)

7 of 14 ISSUED: 08-24-12 SHEET #: 180-9038-2 10-30-12
Wireless Receiver and Power Enclosure Installation
NOTE: The Wireless Receiver Assembly (G) and Power Module Assembly (H) position can be interchanged
based on the display’s connector panel location. Install Wireless Receiver Assembly on the side closest to the
connector panel.
Loosely attach the enclosure mounting brackets (I) to the wireless receiver assembly (G) with two 1/4-20
decorative screws (J) and two 1/4-20 nuts (K) as shown in fi g. 2.1. NOTE: The enclosure mounting bracket can
be installed with the inside notch facing downward if additional side-to-side adjustment is needed. Attach the
mounting brackets (I), open end of notch facing downward, to the right tilt bracket assembly (B) with two 1/4-20
decorative screws (J) and two 1/4-20 nuts (K) as shown in fi g. 2.2.
Adjust the position of the wireless receiver assembly (G) to your desired location as shown in fi g. 2.2. Once in
position, tighten the four 1/4-20 decorative screws (J) using 4mm allen wrench (P).
2
fi g. 2.1 fi g. 2.2
K
B
C
G
J
INSIDE NOTCH
J
I
G
K
INSIDE NOTCH
3
fi g. 3.1 fi g. 3.2
J
J
I
H
H
K
K
INSIDE NOTCH
Loosely attach the enclosure mounting brackets (I) to the power module assembly (H) with two 1/4-20 decorative
screws (J) and two 1/4-20 nuts (K) as shown in fi g. 3.1. NOTE: The enclosure mounting bracket can be installed
with the inside notch facing downward if additional side-to-side adjustment is needed. Attach the mounting
brackets (I), open end of notch facing downward, to the left tilt bracket assembly (C) with two 1/4-20 decorative
screws (J) and two 1/4-20 nuts (K) as shown in fi g. 3.2.
Adjust the position of the power module assembly (H) to your desired location as shown in fi g. 3.2. Once in
position, tighten the four 1/4-20 decorative screws (J) using 4mm allen wrench (P).