Peerless-AV WSP824 - Installation - Manual

ISSUED: 03-24-09 SHEET #: 125-9058-1
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
1 of 2
Model: WSP824,
WSP824-W
Use a stud finder to locate stud centers. Use wall
plate (A) as a template to mark stud centers
through slots. Drill 3/4" (19 mm) dia. holes through
drywall and studs. Insert togglers (E) as shown
below. Six 1/4-20 x 2.5" phillips screws (D) and six
washers (C) are provided. Place screws (D) through
wall plate (A). Partially fasten the toggler (E) to the
back of the screw. Pivot ends of toggler (E) 90°.
A
B
C
D
E
D
C
E
A
Pull screw (D) back until toggler (E) hits the
inside of the metal stud. Fasten all six screws
(D) tight, until wall plate (A) is flush with wall.
Push toggler (E) through hole.
D
E
A
C
Installation and Assembly:
Metal Stud Wall Plate for FPS-1000 or SP850
Maximum Load Capacity: 125 lb (57 kg)
IMPORTANT! Read entire instruction sheet before you start installation and assembly.
• Make sure that mounting screws are anchored into
the center of the studs. The use of an "edge to edge"
stud finder is highly recommended.
WARNING
A
E
D
E
D
A
WSP824 WSP824-W
Description Qty. Part # Part #
A 24" wall plate 1 024-1049 024-2049
B 1/4-20 x 1/2 phillips head screw 4 510-9108 510-9108
C 1/4" flat washer 10 540-9440 540-9440
D 1/4-20 x 2.5 phillips head screw 6 520-9522 520-9522
E toggler 6 590-1093 590-1093
Parts List