Peerless-AV GC-WII - Installation - Manual (Page 6)

6 of 7 ISSUED: 1-17-11 SHEET #: 125-9179-2 07-31-12
Using lock down plate ( A) as a template mark the center of the four mounting holes. Drill four 1/2" holes through
drywall. NOTE: It may be necessary to drill 5/32" pilot holes prior to drilling 1/2" holes. Install togglers (I) as shown
in figure 1.3. loosely fasten lock down plate ( A) to wall using four 1/4-20 x 1.5" screws (D) using 4 mm allen
wrench ( H) as shown in figure 1.4. level, hold, and then tighten all screws.
1
• Drywall must be 1/2" or thicker.
• Make sure that the wall will safely support the combined load of the equipment and all attached hardware and
components.
WARNING
Installation to Drywall
rotate toggler ( I) clockwise to wedge it against
inside walls.
Push into hole.
Pivot end of toggler ( I).
Slide plastic cap forward while pulling back
firmly on ring.
Break off excess.
I
fig. 1.3
drill
1/2"
hole
I
I
I
I
DrYWAll
D
A
I
Figure. 1.4
1
2
3
4
5
Wii™