Ingalls 35180 - Manual

Installation Instructions
1. Determine change needed for rear toe.
2. With vehicle sitting on turntables, remove rear inner parallel
arm bolts.
3. Install replacement bolt (with flat washer) from the front side
of the bracket. Install cam with lobe down, and locking nut.
4. Tighten slightly, allowing the cam assembly to turn.
5. After both sides are installed, adjust rear toe and tighten cam
assemblies to 66 ft lbs.
6. Complete alignment and road test vehicle.
ING3518-72397
Copyright © 1997-04 Ingalls Engineering Co., Inc.