Ingalls 29700 - Manual

Ingalls
Product Installation Instructions
ING29700-012103
Part Number 29700
CAUTION: Observe proper safety and repair procedures for installation of all chassis parts. Some chassis parts require
specialized tools and experience and therefore MUST be installed by a qualified technician otherwise an unsafe vehicle
and/or personal injury could result. Wear safety glasses and other protection.
WARNING: Before beginning, check for any damaged or loose suspension connections. Loose connections here
indicate worn or broken parts which MUST BE REPLACED. Failure to replace a damaged or worn spindle and/or link
may cause the wheel to separate from the vehicle, possibly resulting in serious personal injury.
NOTE: This part is intended to replace the factory installed fixed camber washer located on the rear lower arm mounting
bolt.
1. Following the owner’s manual procedures, safely raise and support the rear of the vehicle.
2. Remove the nut from the lower arm rearward mounting bolt and remove the factory indexing washer.
3. Install Ingalls New slotted washer in the same fashion as the factory washer was installed. The indexing groves
should be facing outward.
4. Place the New locating washer over the bolt with the matching indexing grooves facing inward. These grooves lock
together.
5. Install the factory nut on the factory bolt far enough but still allow the bolt to slide.
6. Adjust camber by moving the lower arm. A pry bar may be used between the lower arm and the frame bracket to aid
in moving the arm outward.
7. Before tightening, ensure that the grooves of the slotted washer and the locating washer are meshed together
properly (sides of both washers should be parallel). Torque the lower arm mounting bolt to 111 Ft-Lbs [150 N-m].
8. Correct the toe adjustment to the factory specifications.
9. Install tire and wheel, lower the vehicle and road test.
ALWAYS CHECK FOR SUSPENSION CLEARANCE
Modifying any suspension component may change other part clearances and cause binding or interferences. After
installing any Ingalls’ product, the suspension must be checked for binds or interference between all components, other
arms and the chassis. Be sure that all control arms, struts and steering ends move freely through the full movement of
the suspension (springs may need to be removed to fully check component travel). Installing any Ingalls’ product on a
modified vehicle (lowered or raised) from the original factory design requires a detailed check of all suspension
components and their movements. Ingalls recommends that a trained technician install all products.
Limited Warranty
Subject to Disclaimer. All Ingalls products are warranted against defects in materials and workmanship for ninety (90)
days from date of purchase. During the warranty period, Ingalls will repair, or at its option replace at no charge,
components that prove to be defective. The product must be returned, shipping prepaid, to Ingalls facility. This limited
warranty does not apply if the product is damaged by accident or misuse. The foregoing warranty is in lieu of all other
warranties expressed or implied including but not limited to any implied warranty of merchantability, fitness, or adequacy
for any particular purpose or use. Ingalls shall not be liable for any special, incidental or consequential damages whether
in contract, tort, or otherwise resulting from the use or the inability to use the product.
Warranty Disclaimer
Use of this product in competition, or use on vehicles altered from original manufacturer’s specifications or settings,
EXPRESSLY VOIDS WARRANTY. The user is urged to inspect for suspension binding or interference when the product
is used in these manners. However, due to the varying conditions and manner of use which the product will be subjected
to in such uses, Ingalls Engineering Co., Inc. makes no warranties, either express or implied, including any warranty of
merchantability or fitness for a particular purpose for use in competition or with specifications or settings other than those
specified by the original manufacturer’s specifications.
Copyright © 2003-04 Ingalls Engineering Co., Inc.