Ingalls 93046 - Manual

© Ingalls Engineering Co., Inc. - 2011 Cherry Street, Suite 104 - Louisville, CO, 80027
(800) 641-9795 - (303) 665-7800 - Fax: (303) 665-7810 - www.IngallsEng.com
Installation Instructions for 93046
Ingalls Engineering Stiffy ™ Engine Torque Damper for 2008+ Scion XB
CAUTION: Observe proper safety and repair procedures for installation of all chassis parts. Some chassis parts require
specialized tools and experience and therefore MUST be installed by a qualified technician; otherwise and unsafe vehicle and/or
personal injury could result. Wear safety glasses and other protection.
WARNING: Before beginning, check for any damaged or loose motor mounts. Pull back and forth on the motor by hand or using
a pry bar. Loose connections here indicate worn or broken parts which MUST BE REPLACED. Failure to replace a damaged or
worn motor mount and/or link may cause the major damage, possibly resulting in serious personal injury. Installer MUST check
for proper clearance. Modification(s) may be required. Please proceed ONLY if the vehicle owner is completely aware of these
potential modifications.
Estimated Installation Time: 1 Hour Technical Rating: Easy
Included Parts List:
Required Tools for Installation:
1 - Stiffy ™ Engine Torque Damper Metric Sockets
1 - Engine Bracket Metric Box Wrenches
1 - Chassis Bracket Crescent Wrench (up to 27mm)
1 - Cable Tie 3/8” Torque Wrench
1 - Hardware Kit 3/8” Socket Driver (Wrench)
Step 1: Under the hood, locate the passenger’s side upper strut mount with 3 M10 nuts. Remove the two M10 nuts
(14mm HEX) on the inside as shown. Install the chassis bracket as shown in Figure 1.
Figure 1 Figure 2
Step 2: Locate passenger’s side engine mount and remove the rear M12 bolt and front M12 stud/nut combo as
shown in Figure 2. Note: there is a third bolt still attached, so there is no need to support the motor. Place the two
large spacers over the holes. Fit Engine Mounting Bracket over the spacers and secure using the two longer M12
bolts provided.