Newport Brass 26-28 - Manual

2001 CARNEGIE AVE
SANTA ANA, CA 92705
©2010 Brasstech, Inc. Newport Brass is a registered trademark of Brasstech, Inc.
www.newportbrass.com
Single & Double Towel Bar / 2 & 3 Post Tissue Holder
Installation Instructions
Model No.
26-01, 26-02, 26-03, 26-04, 26-05, 26-28, 26-29
Recommended Installation by a Professional Contractor
1. Using the table below, measure the appropriate distance between post centers. (See Fig. 1)
Note: Hole locations should be level.
· 18" Single Towel Bar - 18 3/8"
· 18" Double Towel Bar - 18 5/8"
· 24" Single Towel Bar - 24 3/8"
· 24" Double Towel Bar - 24 5/8"
· 30" Single Towel Bar - 30 3/8"
· Tissue Holder (2 Post) - 6 1/4"
· Tissue Holder (3 Post) - 6 1/4" (2x), (See Fig. 2)
2. Drill hole(s) in wall at points marked using the appropriate drill size:
· Wood Screw (#10 x 1 3/4”) - use: 1/8" Drill
· Toggle Screw (10-24 x 3”) - use: 9/16" Drill
3. Loosen SETSCREW (4) in FLANGES (1) and remove POSTS (3). Fasten FLANGES (1) to
wall using either WOOD/TOGGLE SCREWS (2). (See Fig. 3).
Align the Flange (1) so that upper flat is level.
4.Thread POST (3) into FLANGE (1). Position POST (3) height to 2” from mounting surface.
Secure POSTS (3) into place by tightening SETSCREWS (4). (See Fig. 4)
Place ESCUTCHEONS (3) onto the base of END POSTS (4). (See Fig. 5)
4a. Towel Bars (Single): Assemble BAR (5) into END POSTS (4). Slide onto BASES
(1) and secure into place with SETSCREWS (6). (See Fig. 5)
4b. Towel Bars (Double): Slide END POSTS (4) onto BASES (1) and secure into
place with SETSCREW (6). (See Fig. 6)
4c. Tissue Holder (2 & 3 Post): Slide END POSTS (4) onto BASES (1) and secure
into place with SETSCREWS (6). Place HOLDER(S) (7) between END POSTS (4).
(See Fig. 7)
Distance between
posts
Fig. 1
Fig. 2
Fig. 3
2
1
3
1
Fig. 4
Fig. 5 Fig. 7
5
4
7
6
4
3
8
7
3
5
Distance
between
posts
Distance
between
posts
7
4
3 5
Fig. 6
2-1/16”
3
4