Newport Brass 17-28 - Manual

Towel Bar / Towel Ring / Robe Hook / Tissue Holder
Installation Instructions
Model No.
17-01, 17-02, 17-09, 17-12, 17-28
Recommended Installation by a Professional Contractor
1. Using the table below, measure the appropriate distance between post centers. See Figure 1.
Note: Hole locations should be level.
· 18" Single Towel Bar - 18 9/16"
· 24" Single Towel Bar - 24 9/16"
· Tissue Holder - 6 1/4"
2. Drill hole(s) in wall at points marked using the appropriate drill size:
· Wood Screw (#6 x 2”) - use: 3/32" Drill
· Toggle Screw (6-32 x 3”) - use: 3/8" Drill
3. Dis-assemble END POST (7) from POST (3). See Figure 4. Remove BONNET (6) and slide
ESCUTCHEON (5) from POST (3). See Figure 3. Fasten FLANGE (1) to finished wall using
either WOOD/TOGGLE SCREWS (2). See Figure 2.
4. Position POST (3) height to 2 3/16” from mounting surface. Secure POST (3) into place by
tightening SETSCREW (4). See Figure 2.
5. Place ESCUTCHEON (5) and thread BONNET (6) onto POST (3). See Figure 3.
6a. Towel Bars: Assemble TOWEL BAR (8) between END POSTS (6). Place END POST (7)
onto POST (3) and secure into place with SETSCREW (4). See Figure 4.
6b. Towel Ring / Robe Hook: Place towel bar assembly END POST (7) onto POST (3) and
secure into place with SETSCREW (4). See Figure 5.
6c. Tissue Holder: Place END POST (7) onto POST (3) and secure into place with
SETSCREW (4). Place HOLDER (8) between END POST (7). See Figure 6.
Fig. 2
3
1
6
3
Fig. 3
Fig. 4 Fig. 6
7
4
7
4
8
7
7
3
3
7
7
4
Fig. 5
3
3
3
3
2 3/16”
4
5
2
4
8
4
Distance between
posts
Fig. 1