Newport Brass 19-28 - Manual

Towel Bar / Towel Ring / Robe Hook / Tissue Holder
Installation Instructions
Model No.
19-01, 19-02, 19-04, 19-05, 19-09, 19-12, 19-28
Recommended Installation by a Professional Contractor
1. Using the table below, measure the appropriate distance between post centers. See Figure 1.
Note: Hole locations should be level.
· 18" Single Towel Bar - 18 5/8"
· 24" Single Towel Bar - 24 5/8"
· 18" Double Towel Bar - 18 5/8"
· 24" Double Towel Bar - 24 5/8"
· Tissue Holder (2 Post) - 6 1/4"
2. Drill hole(s) in wall at points marked using the appropriate drill size:
· Wood Screw (#6 x 2”) - use: 3/32" Drill
· Toggle Screw (6-32 x 3”) - use: 3/8" Drill
3. Fasten FLANGE (1) to wall using either WOOD/TOGGLE SCREW (2). See Figure 2.
4. Place ESCUTCHEON (3) onto FLANGE (1). See Figure 3.
5a. Towel Bar: Assemble TOWEL BAR (6) to END POST (5). Place END POST (5) onto
FLANGE (1). Secure with SETSCREW (4). See Figure 4.
5b. Towel Ring / Robe Hook: Place END POST (5) onto FLANGE (1). Secure into place
with SETSCREW (4). See Figure 5.
5c. Tissue Holder: Place END POST (5) onto FLANGE (1) and secure with SETSCREW
(4). Place HOLDER (7) between END POST (5). See Figure 6.
Distance between
posts
Fig. 1
Fig. 2
2
1
3
1
Fig. 3
Fig. 4 Fig. 6
6
4 5
4
7
5
1
1
3
4
5
1
1
Fig. 5
6