Newport Brass 280D - Manual (Page 2)

Where applicable, remove TEMPORARY PLUG (1) from fitting in wall.
Apply thread sealant to both ends of appropriate length NIPPLE (2), (not supplied).
Tighten NIPPLE (2) onto SUPPLY FITTING (4).
Tighten SUPPLY ELBOW (3) onto NIPPLE (2).
Hand Shower & Hose Installation
Place RUBBER WASHER (1) into both ends of HOSE (2).
Attach the hex end of HOSE (2) onto SUPPLY ELBOW (3).
Attach HAND SHOWER (4) onto conical end of HOSE (2).
Place HAND SHOWER (4) into SLIDE BAR HOLDER (5).
To adjusting Hand Shower on Slide Bar
Loosen or tighten COLLAR NUT (6) to allow HOLDER (5) movement to desired position.
Loosen CAP HANDLE (7) and move HOLDER (5) to desired vertical location. Retighten CAP
HANDLE (7) to keep HOLDER (5) in place.
4
1
2
3
(949) 417-5207
NWP-280D Santa Ana, Ca. 92705 10/10/2011
www.brasstech.com
2
1
3
7
6
5
4
1