R&M Materials Handling END TRUCKS BRIDGE DRIVES WHEEL BLOCKS GES Drive Manual - Manual (Page 7)

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
%
: (937) 328-5100
FAX: (937) 325-5319
7/11
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
F
If machinery is operating under heavy conditions (high temperature, high humidity level, difficult
atmosphere) the lubricant shall be changed regularly. When necessary, pump the old lubricant out
from the breather plughole and refill the gear with a fresh lubricant. See ‘Lubricants’ section for the
correct lubricant type and lubricant amount.
3.6 Removing the drive
I
Ensure that the working area is safe and the machine cannot be started accidentally when
doing the assembly work. Be sure to switch off and lock out power at the main switch to
avoid an electrical hazard.
•
Disconnect the power supply plug from the motor.
•
Remove the mounting bolts from the drive.
•
Pull out the unit from the wheel.
•
Assemble the new unit according to the instructions in section ‘Assembling the drive’.
4 MF06 motor with Compact or DC brake
2 1 7 8 6 5 4 3
9
10 11 12
DC
CB
c_MF06a1
DC= DC-brake
CB=Compact brake
1. Mounting bolts for traveling gear
2. Motor
3. Friction disc
4. Brake disc
5. Aluminum ring
6. Adjustment nut for brake air gap (self-locking)
7. Brake cover
8. Power supply plug 9. Rectifier (DC brake motor)
10. Brake (DC brake motor)
11. Brake disc (DC brake motor)
12. Friction plate (DC brake motor)