Powersolve SR10-12 Series User Manual

Dc-dc switching regulator, Features

Advertising
background image

Powersolve Electronics Ltd.  8A Arnhem Road,  Newbury, RG14 5RU.  England

Tel: 01635 521858  Fax: 01635 523771  Email: [email protected]

www.powersolve.co.uk

DC-DC Switching Regulator

SR10-12 Series
10A SIP & SMT Packages
Non-Isolated

Features

Non-Isolated POL Converter

SIP / SMT Packages

Output Current 10A

Input Voltage Range 9 - 14VDC

Efficiency to 95%

Over Temperature Protection

Continuous Short Circuit Protection

Remote On/Off Control

INPUT
Input Voltage Range

9.0 - 14V (12V nominal)
8.3 - 14V (Models with suffix “W”)

Under Voltage Lock-out

8.0V typ. (Power Up)
7.7V typ. (Power Down)

Input Filter

Capacitive

Remote On/Off Control

Open Circuit or equal to Vin (Module On)
<0.4VDC (Module Off)

OUTPUT
Voltage Accuracy

±1.5% max.

Transient Response: 25% step load change

<200µ sec.

Ripple and Noise (20MHz BW) [3]

20mV rms, 50mV pk-pk max.

Temperature Coefficient

±0.03% / °C

Short Circuit Protection

Continuous

Line Regulation [1]

±0.2%

Load Regulation [2]

±0.5%

Capacitive Load, Low ESR

8000µF max.

External Trim Adj. Range

±10%
+5% / -10% (SR10-12-05TH / SM)
0.75 - 5.0V (SR10-12-05WTH / WSM)

GENERAL
Efficiency

See Table

Isolation Voltage

Non-Isolated

Switching Frequency

300KHz typ.

Over Temperature Protection

120°C typ.

Operating Temperature Range

-40°C to +85°C

Power Derating

See derating curves

Storage Temperature Range

-55°C to +125°C

Dimensions

50.8 x 13.0 x 8.30 mm (2.00 x 0.512 x 0.327 Inches) (SIP Package)
33.0 x 13.46 x 9.3 mm (1.30 x 0.53 x 0.366 Inches) (SMT Package)

Case

Non-potted open frame type

Weight

10g

Electrical Specification

Typical at nominal line, full load & 25°C unless otherwise stated.

NOTE:
1. Measured from High Line to Low Line.
2. Measured from Full Load to No Load.
3. Output noise & ripple is measured with a 10µF tantalum & 1µF ceramic capacitor across the output.
4. It is recommended to put a 100µF capacitor with ESR<100mΩ across the input to reduce the input ripple voltage.
5. Suffix ‘N’ to model number for Negative Logic Remote On/Off Control.

Advertising