Braun 7015 Syncro - Manual (Page 5)

5
Keeping your shaver in top shape
Automated cleaning
Available at your dealer or Braun Service Centres is the
Clean&Charge. It automatically takes care of all cleaning
and lubrication needs of your shaver.
Manual cleaning
For easy cleaning after each shave, switch the shaver
off. Press the release buttons to lift the shaver foil
(do not remove the foil completely). Switch on the shaver
for approx. 5-10 seconds so that the shaved stubbles can
fall out.
For a thorough cleaning (weekly), remove the shaving
foil and tap it out on a flat surface. Using the brush,
clean the cutter block and the inner area of the pivoting
head. About every four weeks, clean the cutter block
with Braun cleaning agents.
If your skin is very dry and you notice a reduced perform-
ance of the shaver, apply a drop of light machine oil onto
the shaver foil.
Replacing the shaving parts
The shaver foil and cutter block are precision parts that,
in time, are subject to wear. Replace your foil and cutter
block every 18 months and get a 25% better shave.*
(Shaver foil and cutter block: part no. 7000)
(* Overall evaluation from Braun users comparing their
shave with new parts and those used for 18 months.)
Accessories
available at your dealer or Braun Service Centres:
• Shaver foil and cutter block (part no. 7000)
• Wall holder
Subject to change without notice.
This product conforms to the EMC-Require-
ments as laid down by the Council Directive
89/336/EEC and to the Low Voltage Regulation
(73/23 EEC).
oil
10
10
7000
7000
Syncro
5495453_S 4-42 Seite 5 Freitag, 17. November 2000 9:23 09