Airbagit Spindles, Coilsprings, Shock Relocator Kit, And Control Air Arm - Manual

SPINDLES, COILSPRINGS, SHOCK
RELOCATER KIT, AND
AIRARM INSTRUCTIONS
1. Using floor jack, jack up truck till wheels are off the ground and support with jack
stands.
2. Remove wheels.
3. Unbolt upper shock bolt and 2 lower shock bolts and remove shock.
4. A coil spring compressor should be used to keep the coil compressed. If not using
spring compressor is not being used then extreme caution should be used when
dislocating the lower ball joint in the next step as the coil will unload with great
force once the lower ball joint is broken loose.
5. Using ball joint separator dislocate lower ball joint from spindle. Make sure upper
control arm and spindle are supported by wedging something between upper arm
and frame.
6. With lower arm unbolted from the spindle remove bolts from lower control arm
mounts at the frame and remove the lower control arm.
7. Bolt aftermarket lower control arm in place with the straighter side with the
bigger bolt hole to towards the front of the vehicle.
8. Bolt lower ball joint to lower position of spindle.
9. Support lower control arm with floor jack.
10. Using ball joint separator again dislocate upper ball joint from spindle. Make sure
once again that the spindle is supported to prevent brake line from being
stretched.