Airbagit I-Beam - Manual

Typical Front
Typical Front Air Bag #3
Installation Instructions
(click on each image to purchase individual parts)
DIAGRAM #11 AIR BAG FRNT KIT 3.PDF
TOP BRACKET
AIR BAG
BOTTOM BRACKET
I-BEAM
TOP BRACKET
AIR BAG
BOTTOM BRACKET
I-BEAM
THIS IS A WELD-ON KIT. BOLT HOLES ARE FOR LOCATING PRIOR TO WELDING. THIS KIT
IS FOR USE WITH FACTORY I-BEAMS. IF YOU HAVE HAD LOWERED BEAMS INSTALLED,
YOU WILL HAVE TO USE AN OPTIONAL LOWERED BARREL.
1. REMOVE SHOCK ABSORBERS AND COIL SPRINGS.
2. REMOVE THE STOCK UPPER SPRING/SHOCK MOUNTS FROM THE FRAME. THE PAS-
SENGER SIDE FRAME RAIL IS FLAT AND THE NEW PART WILL BE INSTALLED DIRECTLY
CENTERED OVER THE SPRING PERCH MOUNT.
3. THE DRIVERS SIDE IS CURVED AND MUST BE CUT WITH A DIE GRINDER. REMOVE
JUST ENOUGH TO FIT NEW BRACKETS SNUGLY IN PLACE. TACK/WELD OR BOLT TEM-
PORARILY IN PLACE. WHEN YOU ARE SURE OF POSITION, THEN HAVE A CERTIFIED
WELDER APPLY FINISHED WELDS.
DO NOT RUN AIRBAGS WITH LESS THAN 10LBS PRESSURE. NO WARRANTY ON AIR
BAGS, IT IS YOUR RESPONSIBILITY TO MAKE SURE AIRBAGS ARE CLEAR OF ANY
OBSTRUCTIONS.
IMPORTANT:
TACK-WELD AIRBAG BRACKETS TO FRAME MAKING SURE THAT THE BAG IS STRAIGHT
UP AND DOWN IN RELATION TO THE UPPER BAG MOUNT AND THE I-BEAM SPRING
PERCH BOLT, WHEN YOU ARE AT YOUR DESIRED RIDE HEIGHT. DO NOT USE ANY
EXISTING HOLES IN THE NEW BRACKETS AS A GUIDE. RADIUS ARMS WILL ALLOW AN
ADDITIONAL 1/2” FINAL ADJUSTMENT IF NEEDED
all FORDS WITH IBEAMS 1980 THRU 1996
and FORD RANGERS 1982 THRU 1997
INSTRUCTIONS: