Braun Clean & Charge (Flex Integral) - Manual (Page 8)

9
C Operating your Clean&Charge
• Connect your Clean&Charge with the cord
set to the mains electricity supply.
Open the contact bow (2) by pressing the
release button (3). After shaving, switch the
shaver off and place it upside down into the
Clean&Charge. The swivel head must not be
locked (switch «head lock» position down).
• Select the operation mode by toggling with
the mode selector (4):
«clean»
(about 15 min)
«clean« + «charge» (about 75 min)
«charge» (about 60 min)
The corresponding lights will come on.
(With cord shavers, only the «clean» function
can be selected.)
• Slide down the contact bow (2) to connect
the shaver and to start the selected
programme.
If no programme is selected, the default
function «clean» will be started.
• Do not interrupt a running programme,
as it leaves the shaver wet and not fit for use.
If interruption is needed nonetheless, press
the release button (3).
• After a programme has finished, the corre-
sponding light will go out. If later on, the
charging light of the shaver comes on again,
this indicates that the shaver is being
recharged to maintain its full capacity.
Prior to the next shave, press the release
button to release the shaver.
• When the «cartridge» light starts flashing,
the remaining fluid in the cartridge is
sufficient for about 5 more cleaning cycles.
After these 5 cycles, the cleaning
performance will be reduced and the
cartridge has to be replaced.
• When the «cartridge» light illuminates
constantly, the cleaning function is locked
and a new cartridge has to be installed.
Only then, the next cleaning cycle can be
started.
• A cleaning cartridge should be sufficient
for about 30 cleaning cycles. With daily use,
the cleaning cartridge should be replaced
approx. every 4 weeks.
• The hygienic cleaning solution cartridge
contains alcohol which, once opened, will
naturally evaporate slowly into the surround-
ing air. Each cartridge, if not used daily,
should be replaced after approx. 8 weeks.
• Do not leave the appliance plugged-in
without the shaver inserted.
• Clean the housing from time to time with a
damp cloth, especially the opening where
the shaver rests.
Subject to change without notice.
This product conforms to the
EMC-Requirements as laid down
by the Council Directive 89/336/EEC
and to the Low Voltage Regulation
(73/23 EEC).
5302450_C&C_S6-44 Seite 9 Montag, 11. Juni 2001 3:41 15