S&B Filters Cold Air Intake Kit - Cotton Filter 75-2529-1 - Manual

5/1/2008
REV-B
(909) 947-0015 PHONE • (909) 947-0603 FAX
www.sbfilters.com
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
(OVER)
S&B P/N 75-2529-1
2001-2003 Ford
Explorer Sport, Sport
Trac, Ranger
4.0L V6 SOHC
* Kit may not fit vehicles with body
lift installed.
1. With the ignition switched off, disconnect
the negative battery terminal.
2. Remove the dust cover from the throttle
body housing.
3. Disconnect the electrical connection for the
MAF sensor.
4. Disconnect the crank case vent hose from
the OE intake tube.
Note:Some models have two vent hoses on the
intake tube.
5. Gently pry up on the clip and remove the
MAF sensor wiring from the intake tube.
6. Loosen the hose clamps on the OE tube and
remove the intake tube
7. Unclip the top of the OE air box and remove
the lid. Pull up on the air box and remove it from
the inner fender.
8.
Remove the MAF sensor from the OE
air box.
9. Locate the S&B air box and the MAF sensor
adaptor hardware.
10. Assemble the MAF sensor. Use a gasket
on both sides of the box opening.
11. Assemble the 5/16 hardware provided, as
show below.
12. Locate the box mount plate in the vehicle.
Push the S&B air box assembly down into the
OE grommets.
QTY PARTS LIST QTY PARTS LIST (continued)
1 3.5” - 2” Adapter 1 5/8” x 2.25” Hose
1 3.25” - 2” Adapter 4 1/4”-20 Hex Head Screws
1 Filter Adapter 4 1/4”’ Washers
1 Intake Tube 2 MAF Sensor Gaskets
1 Air Box 2 5/16” Acorn Nuts
1 Clear Lid 2 5/16” Jam Nuts
1 CARB S ticker 4 Sealing Washers
4 #56 Hose Clamps 1 Rubber Grommet
1 Air Filter 4 18-8 SS Pan Head Screws
TOOLS REQUIRED
7/16 socket & Wrench
Flat head screwdriver
Phillips Head Screwdriver
7,10,13mm Wrench
4,5mm Allen