S&B Filters Cold Air Intake Kit - Cotton Filter 75-5059 - Manual

1. With the ignition switched off and the
parking brake set, disconnect the negative
battery cable on the passenger’s side.
Installation Instructions
Vehicle Application
Year: 2009-13
Make: Chevy/ GMC/ Cadillac
Model:
Silverado/ Sierra 1500, Tahoe/
Yukon, Suburban/ Yukon XL, Escalade ESV/
EXT, Yukon Denali/ XL, Avalanche
Engine: 4.8L, 5.3L, 6.0L, 6.2L V8
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
6.
Disconnect the intake tube from the
throttle body.
9.
Remove the air cleaner box from the
vehicle by carefully pulling it up out of the
factory grommets.
7.
Disconnect the intake tube from the air
cleaner assembly. Then remove the intake
from the vehicle.
2.
Remove the engine cover by lifting it up
out of the grommets, then pull towards the
front of the vehicle.
8.
Using a flat blade screwdriver, remove the
intake tube from the push pin located on the
coolant tube. Then remove the intake from
the vehicle.
P/N: 75-5059 / 75-5059D
SEE EXPLODED VIEW ON PAGE 4
1
Tools Required
• Ratchet and extensions
• 10mm Socket and Wrench
• 3/16” Allen Wrench
• 5/16” Nut Driver or Flat Blade Screwdriver
• Phillips Screwdriver
• 9/16” Wrench
Notes
Kit may not fit with the following
Aftermarket Parts installed:
• Body Lift or Lowering Kit
• Custom Hood
• Throttle body upgrades
S&B Filter Maintenance
Cleanable (KF-1055) . If the enclosed filter is Red, it came pre-oiled
from the factory. When serviced, apply (90g) of S&B oil to the main
body of the filter.
Disposable (KF-1055D) . If the enclosed filter is White, it is a
disposable filter and should be discarded once it reaches capacity.
This filter
(does not require oil) . For more info on S&Bʼs disposable
filter, visit www.sbfilters.com .
3. Disconnect the crank case vent line from
the intake tube plenum by gently pulling it out.
5.
Disconnect the MAF sensor wiring
harness from the MAF sensor. Note: If
equipped, disconnect the Pressure Sensor
wiring harness (located on the air cleaner lid)
at this time as well.
4.
Disconnect the other end of the crank
case vent line from the vehicle by sliding the
locking tab over and pull away from the valve
cover port.
Before You Start
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 4 are present.
• If you are missing any of the components, call our customer
support at (909) 947-0015.
• Do not work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or
the Parking Brake is set.
CARB Status - Exempt
CARB EO #: D-590-8
Legal for use in CA or other states
adopting CA emissions standards
See Page 3 for more info.