S&B Filters Cold Air Intake Kit - Cotton Filter 75-5020 - Manual

8/21/2008
REV-A
(909) 947-0015 PHONE • (909) 947-0603 FAX
www.sbfilters.com
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
(OVER)
S&B P/N 75-5020
2006 Ford F-150 4.6L
∗ Kit may not fit vehicles with the
following Aftermarket Parts installed.
∗ Body Lift
∗ Custom Hood
∗ Throttle Body Upgrade
∗ Throttle Body Spacer
QTY PARTS LIST QTY PARTS LIST
1 (C) Intake Tube 1 (P) 3”-3.5” step adapter
1 (O) Air Box 1 (F) # 56 Hose Clamp
1 (R) Clear Lid 1 (T) #104 Hose Clamp
1 (E) 3.725”x2.938” step adapter 2 (G) # 88 Hose Clamp
4 (I) 5/16-18 SS Screw 1 (D) # 60 Hose Clamp
4 (M) 5/16 Fender Washer 2 (B) # 8 Hose Clamp
2 (N) 5/16-18 Bolt 1 (V) # 52 Hose Clamp
2 (K) 5/16-18 Lock Nut 1 (Q) S&B Air Filter
2 (L) Rubber Spacer 1 (A) 5/8“x25” Hose
1 (J) Filter Adapter 6 (S) 10/24 SS Screws
1 (H) Oval Hump Adapter 6 (U) 10/24 SS Concave Washer
TOOLS REQUIRED
1/2” Wrench & Socket
Ratchet
5/16” Nut Driver or
Flat Blade Screwdriver
T-20 Torx wrench
(supplied with kit)
Phillips head screwdriver
Your S&B Air Filter is
factory oiled and ready
to use. Air Filter P/N
KF-1031 will require 71g
of oil for main body and
17g of oil for the top
when serviced.
1. With the ignition switched off, disconnect
the negative battery cable, use an 8mm
wrench or socket.
2. Disconnect the crank case vent line from
the driver side valve cover to the OE intake
tube and remove from vehicle.
3. Disconnect the electrical connection for
the MAF sensor at the pig tail coming from
the OE intake tube.
4. Loosen the hose clamp at the throttle body
pull out and then towards the left, pulling the
OE intake assembly out of the drivers side
inner fender.
5. Remove the OE rubber grommets from the
inner fender tray (drivers side) and relocate
the wire loom closer to the fender.
6. Install the 3” to 3.5” adapter (P) to the fender
snout on the S&B air box (O), push on as far as
it will go, it may feel loose but will secure with
#56 hose clamp (F).
7. Install the S&B air box (O) and secure
using the 5/16 bolts (N), fender washers (M),
rubber spacers (L) and lock nuts (K)
provided. See diagram below.
8. Place the S&B air filter (Q) inside S&B air
box (O). Offset flange is toward the front of
the vehicle. Snap S&B filter adapter (J) into
S&B air filter (Q) secure with #104 hose
clamp (T).