S&B Filters Cold Air Intake Kit - Cotton Filter 75-3017-2 - Manual

1/16/2008
HIGH PERFORMANCE HIGH PERFORMANCE
COOL AIR INTAKE KIT COOL AIR INTAKE KIT
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
75-3017-2
CHEVROLET/GMC
S10 Pickup; Blazer
S15 Sonoma; Jimmy
V6 4.3L
KIT WILL NOT FIT VEHICLES WITH BODY LIFT
QTY PARTS LIST QTY PARTS LIST
1 4” - 1.25” Adapter 1 1/8” Ring Gasket
1 3” - 3.25” x 3” Adapter 1 1/2” Grommet
1 Intake Box 1 Saddle Clamp
1 CARB Sticker 3 1/4” Washers
1 Instruction Sheet 1 M6 Nylock Nut
1 #52 Hose Clamp 1 M6 SS Washer
2 #60 Hose Clamps 1 M6 x 1.24” Coupling Nuts
2 #64 Hose Clamps 1 Twisted Bracket
3 M6 x 16mm Screws 1 Air Filter
3 M6 Coupling Nuts
1 Intake Tube 1 1/4” Finishing Washer
TOOLS NEEDED
10mm Open End Wrench Phillips head screw driver
10mm Socket & Ratchet Flat Head Screw Driver
4mm Allen Wrench 5/16” Nut Driver
5 mm Allen Wrench
1. Turn off the vehicle’s engine and dis-
connect the negative battery terminal.
2. Disconnect the mass air sensor and the
air temperature senor electrical connections
as shown in the following two photos.
3. Disconnect the crankcase vent line from
the intake plenum.
4. Remove the wing nut that holding the
intake plenum.
5. Loosen the four screws that hold the air box
top to the air box base.
6. Remove the upper air cleaner assembly unit.
7. Remove the nut that holds the air box base
and retain for later step.
9. Pull the release tab and slide the retainer
bracket up to disconnect it from the radiator
core support.
8. Pull the air box up firmly to release the grom-
mets from the retainer bracket.
10. Remove retainer bracket from radiator sup-
port.
11. Use a 7/32” socket to remove the factory
stand off from the throttle body.
12. Use a 5/16” wrench to remove the factory bolt
from the stand off then reinstall the bolt in its proper
location.