S&B Filters Cold Air Intake Kit - Cotton Filter 75-5019 - Manual

1. With the ignition switched off and the
parking brake set, disconnect the negative
battery cables on both batteries.
INSTALLATION INSTRUCTIONS
Vehicle Application
Year: 2007-10
Make: Cheverolet / GMC
Model:
Silverado / Sierra
! 2500HD, 3500
Engine: 6.6L Duramax “LMM”
Tools Required
• 10mm Wrench or Socket
• 1/2” Wrench or Socket
• T-20 Security Torx Wrench (Supplied w/ Kit)
• 5/16” Nut Driver or Flat Blade Screwdriver
• Phillips Screwdriver
Notes
Kit may not fit with the following:
• Aftermarket Parts installed
• Body Lift or Lowering Kit
• Custom Hood
• Intercooler or Turbo upgrades
Before You Start
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 4 are present.
• If you are missing any of the components, call our customer support at (909) 947-0015.
• Do not attempt to work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the Parking Brake is set.
15461 Slover Ave, Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
4.
Pull up on the OE air box to remove it
from the vehicle, there are two press prongs
that go into rubber grommets on the bottom
side.
7.
Place the Air Filter (C) inside the Air Box
(A) , then attach the Filter Adapter (B) clip into
the bottom of the Air Box. Secure using the
5/16” bolts
(G) & washers (T) . Secure the #80
hose clamp (D) at the Filter.
2.
Disconnect the electrical connection at
the MAF sensor on the OE air box tube.
5.
Make sure that the OE grommets are still
in place in the OE air box tray. They may have
pulled out with the air box removal.
9.
Remove the MAF sensor from the OE air
box using the supplied T-20 Torx wrench.
Make sure the rubber seal stays with the MAF
sensor.
3.
Loosen both hose clamps and remove
the OE intake tube from the vehicle.
6.
Remove the headlight housing bolt in the
radiator core support between the passenger
side fender and the hood bumper.
P/N: 75-5019 / 75-5019D
SEE EXPLODED VIEW ON PAGE 3
1
S&B Filter Maintenance
Cleanable (KF-1035) . If the enclosed filter is Red, it came pre-oiled
from the factory. Please visit www.sbfilters.com for the exact oil
amount required after cleaning.
Disposable (KF-1035D) . If the enclosed filter is White, it is a
disposable filter and should be discarded once it reaches capacity.
This filter
(does not require oil) . For more info on S&Bʼs disposable
filter, visit www.sbfilters.com .
8.
Remove the OE Filter Minder and OE
Grommet. Insert the grommet into the Filter
Adapter Tube
(B) . Then push the Filter
Minder into the grommet.