S&B Filters Cold Air Intake Kit - Cotton Filter 75-5003 - Manual

2/1/2010
REV-D
(909) 947 - 0015 PHONE • (909) 947-0603 FAX
www.sbfilters.com
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
(OVER)
S&B P/N 75-5003
2005-2006
FORD Mustang GT
4.6L V8
(excluding models
manufactured prior to April of 2005)
Non hydrocarbon absorber equipped
models only.
For 2005 models not equipped with the HC absorber,
permitted Ford intake part numbers 6R33-9C662-BG
(manual trans) or 6R33-9C662-CG (auto trans).
To verify: Locate the label on the front facing vertical
wall of the lower part of the stock air box.
QTY PARTS LIST QTY PARTS LIST (continued)
1 1/2” x 16” Hose 1 #10-24 Pan Head Screws
1 4.5” - 2” Adapter 1 #10-24 Nylock Nuts
1 Intake Tube 2 #10 Washers
1 Air Box 1 Angled Bracket
1 Clear Lid 1 1/2” x 1/4” NPT Hose Barb
1 Air Filter 2 5/16” - 18 Acorn Nuts
2 #72 Hose Clamps 2 5/16” Jam Nuts
2 #8 Rubber Washers 2 5/16” Bolts
1 MAF Sensor Mounting Plate 4 Sealing Washers
1 MAF Sensor Mounting Gasket 4 SS Pan Head Screws
2 #10-32 Pan Head Screws 1 #8 Hose Clamp
2 #8-32 Pan Head Screws
TOOLS REQUIRED
10 mm Wrench &
Socket
1/2” Wrench & Socket
Flat Head Screwdriver
Phillips Screw Driver
T-20 Torx wrench
(supplied)
1. Turn off the ignition and disconnect the
negative battery terminal.
2. Disconnect the crank case vent line from the
intake tube and the valve cover, remove it from
the vehicle.
3. Loosen the hose clamp that attaches the
intake tube to the throttle body.
4. Disconnect the electrical connection from the
MAF sensor .
5. Unlatch the air box lid and remove the intake
tube and lid assembly.
6. Remove the OEM panel filter from the air box.
7. Loosen the bolt that secures the air box using
a 10mm socket and ratchet.
8. Pull up and remove the air box from the
vehicle.
9. Remove the grommets from the OE air box.
These will be used to secure the S&B air box.
10. Use the # 8 screws and attach the MAF to the
sensor plate with rubber washers between MAF
and plate. Then attach plate to tube. Point the
arrow on the MAF sensor towards the engine.
11. Carefully install the NPT hose barb into the
intake tube making sure not to cross thread, then
install the 1/2” breather hose onto the hose barb.
Next install the 4” round adapter and hose
clamps to the throttle body end of the tube.
12. Install the S&B Intake Tube on to the throttle
body.