S&B Filters Cold Air Intake Kit - Cotton Filter 75-3025-1 - Manual

12/11/2006
High Performance High Performance
Cold Air Intake Kit Cold Air Intake Kit
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
(Over)
75-3025-1
Chevy S10 Pick Up
2.2L-L4
QTY PARTS LIST QTY PARTS LIST QTY PARTS LIST
1 2.75” - 2” Adapter 1 1/2” Grommet 1 Air Filter
1 1/2” x 14” Hose 1 Finishing Washer
1 Intake Box 1 Saddle Clamp
1 Intake Tube 1 1/4” Washer
1 CARB Sticker 1 M6 Nylock Nut
1 Instruction Sheet 1 M6 SS Flat Head Screw
2 #44 Hose Clamps 1 Bent “L” Bracket
1 #72 Hose Clamp 1 1/2” x 1/2” Hose Mender
TOOLS REQUIRED
4mm allen wrench
Flat head screwdriver
10mm & 7/16” socket
wrench
7. Loosen the nut that retains the stock air box.
Remove the air box from the vehicle
9. Loosen the bolt that fastens the resonator
box to it’s mounting bracket
1. Turn off engine and disconnect negative battery
terminal and disconnect the air temperature
sensor electrical connection
2. Unclip the A.C. hose on the radiator shroud
3. Loosen the hose clamp on the intake tube
at the air box
5. Loosen the hose clamp on the intake tube
at the resonator box and detach
8. Press down on the tab and lift and remove the
air box mounting bracket from the radiator core
support
4. Prey up the two push pins that fasten
the intake tube to the radiator
6. Lift out the stock intake from the vehicle 10. Loosen the hose clam connection from
the resonator box to the throttle body
11 . Disconnect the crank case vent hose from the
valve cover and remove the resonator box
12 Install the rubber grommet into the hole in
the S&B cold air intake tube