Swanstone TC-6072TR - Installation - Manual

Model TC-6072-TR
(for bathtub installation)
Model TC-105-TR
(for shower installation)
Included in Kit:
TC-6072-TR
• Three molding pieces
3 3/4" wide x 105" high
• Four rosettes 4" x 4"
• One tube adhesive
• One tube color
coordinated caulk
TC-105-TR
• Four molding pieces
3 3/4" wide x 105" high
• Four rosettes 4" x 4"
• one tube adhesive
• one tube color
coordinated caulk
Molding and Rosettes
Installation Care and Cleaning
Before you start
The Swanstone Molding and
Rosettes may be installed over
any solid surface. This product
makes a beautiful casing
around doors, windows, and
mirrors. For the purpose of instruction, this procedure will
address an application over a
bathtub or shower floor using a
Swanstone wall panel. It may
also be installed by itself or
with other wall materials.
THRESHOLD ROSETTES
1. Choose the rosette design
pattern that you wish and
apply a glob of adhesive to the
opposite side of the design
that you select. The most
desirable placement will line
up the front edge of the rosette
with the front edge of the bath-
tub or shower floor threshold.
Follow this procedure for the
application of both threshold
rosettes.
VERTICAL MOLDING &
ROSETTES
Select two of the molding
pieces. Measure and cut to fit
the
vertical application.
Remember that a rosette piece
will be positioned above the
molding piece. Take this into
consideration prior to measur-
ing and cutting.
TRIAL FIT
Check with a level. Note that the molding pieces are slightly nar-
rower than the rosettes. Therefore, the molding pieces should be
centered over the bathtub or shower floor threshold rosette. Mark
the location of the vertical molding with "tick" marks. These
"tick" marks will be used for final fit. Temporarily secure the mold-
ing to the wall with masking tape. Select the molding design you
wish and the rosette design that is consistent with the threshold
rosettes, and trial fit and tape into position above the vertical
molding pieces.
If you have selected a
Swanstone solid surface wall
panel to complement this
application, install the molding
and rosettes first. Prior to
installing the moldings and
rosettes, keep in mind the size
limits of the wall that you are
installing. After you have
installed the molding and
rosettes, follow the installation
instructions provided in the
wall kit.
When installing the side walls,
be aware that it will be neces-
sary to "notch" the side wall
panels around the ro s e t t e s .
Take these measurements into
consideration prior to final fit
of the side wall panels.
Molding
Side A
Fluted Rosette
Side B
Butterfly Rosette
Side A
Circle
Rosette
Side B
Star
Tools Required:
Tools needed are a saber saw,
drill, ruler, level, masking tape,
and caulking gun.